LED lamp protector, two way switch protector, anti glare, prevent
strobe and prevent surge
Brief introduction
This product is a full range of power supply protection products
designed by our company for LED outdoor lighting system. This
product can be installed in the lampshade of LED lamps or in the
control cabinet. It is applied to many outdoor lighting systems
such as LED street lamp, tunnel lamp, outdoor landscape lamp and so
on. Different versions of the design are mainly to meet the
different lines, divided into line connection and terminal
connection two wiring ways, some versions also equipped with signal
(DALI, RS485, 0-10V) protection function, mainly to meet the
monitoring and regulation function of the LED lighting system.
Working principle of product
When the surge protector has no voltage, the impedance is very
high, which means that the circuit breaker is open. When the
voltage occurs, the impedance drops to a few Europe, and the surge
current will flow through the surge protector and will not enter
the device. At the same time, because the surge protector has a
small impedance at this time, the voltage on both sides of the
surge is relatively small, and because he is in parallel with the
protected equipment, it prevents the equipment from suffering from
large surge power. Pressure, so as to play the effect of discharge
and pressure limiting.
Product features
1. instantaneous lightning protection, high endurance
2. compact structure, small size, easy to install
3. band failure protection, temperature protection, optional remote
communication mode, with LED working instructions.
Product specification
| Model | TR6D |
| Rated Operating Voitage | UC | 275 |
| Voltage protective level | Up(KV)≤ | 0.8 |
| Max discharge current | Imax(KA) | 6 |
Nominal discharge current
| In(KA) | 3 |
| Operating condition | Temp:-40℃~+70℃ |
| RH≤95%(25℃) |
| Sea level elevation≤3km |
| Remarks | Other max continuous operating voltage can be customized |
Use of attention
1. installation personnel need corresponding construction
qualification. N and L line cannot be reversed.
2. after the connection is completed, check the wiring correctly
and link reliability again, then switch on the power, and then put
into operation.
3. lightning protector must be disconnected when installing and
maintaining, and no live operation is strictly prohibited. Y is to
prevent electric shock.
Company profile
Thor is all about protecting against the damaging effects of power
transients. It is our goal and mission to connect our customer
challenges with high-quality, right-priced solutions and products –
completed by unrivaled customer service and technical support.
Product packaging:Carton packing
Transportation method
1. Express company: FEDEX,UPS,DHL,TNT
2. Trains, ships, aircraft transport
